• Z-Wave Forum
    Home Automation made simple
It is currently Fri Aug 18, 2017 12:17 am
  • View new posts
  • View unanswered posts
  • Who is online
  • In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
  • Most users ever online was 33 on Fri Apr 21, 2017 2:30 pm
  • Users browsing this forum: No registered users and 1 guest

New Software available - 4.040

Home Center 2 / Home Center Lite

by Dennis » Thu Mar 26, 2015 10:03 am

This version is hot fixing version addressing some of issues reported by users.

4.040


> New Features:

Device adding from iPhone/Android Phone application (requires newest app and 4.040)


> Resolved Issues:

Satel support

Slow communication between mobile apps and Home Center

No icons on mobile devices

Impossible to control Linear Dimmer

Magic Scenes conditions for Dimmer

Alarm Fibaro - not showing time to arm when arm delayed

Polling - please check your configuration.

#0003027: Z-wave network configuration don't save changes

#0001956: Outputs of Satel Intgera alarmsystem cannot be controled anymore via the scene (bloks)

#0002145: Warning satel partition

#0002316: 4.024 If you are going to keep the RAM diagnostic, please explain the meaning of used and free

#0003016: HC2 out of memory after a few hours of operation

#0003034: 4.037 - Memory Utilization Shoots-up with each Backup run

#0001992: FGK-101 with a DS18B20

#0002920: Danfoss sw1.01 doesn't follow the morning setting of heating panel

#0002575: Universal Binary Sensor (UBS) lacks "sceneActivation"

#0001727: Trying to set parameter on Everspring SP814 Motion detecto

#0002590: Everspring AN145 Bulb Reconfiguration Problem

#0002450: Motion Sensor always engaged

#0003032: Waking up dead nodes.


> Device Support:

D-Link DCS-932L
Improved Fibaro Smoke Sensor


> We advise:


Reconfiguration of a Satel alarm.

Avoiding local polling interval smaller than 30s. This may cause high network traffic and block communication.

Note that high RAM memory usage indication in the diagnostic interface might not mean that the amount of available memory is low. Excess memory is used to speed up the operation.


> Known issues:

Android version of the Fibaro mobile app does not display icons for following devices properly:
- NetAtmo Thermostat
- NetAtmo Weather Station
- Sonos

Global polling interval is set to a fixed value (120s), this may cause a delay in operation of large Z-Wave networks.

Inconsistencies in Satel interface.

Power Mettering may not work properly for some devices
RGBW Controler may not work propery when used in in/out mode
Alarm Panel doesn't work in some specific configurations

Plugins for TV Sets of various manufacturers may not work with its newes firmware due to restricions provided by new devices firmware. There will be added detalied information about suported firmwave versions within plugins.

-
Breached sensor with Arm Delay causes instant alarm after being armed
Data range selection in event panel doesn't work properly
Devices imported via Gateway Connection may have no icons
Gateway Connection status of dead device between master and slave controller may be different
Devices not properly configured on 3.X may not be converted properly
On mobile clients devices may be visible in different categories than configured
Horstmann Thermostat HRT4-ZW higher battery usage in some cases
Doorlocks some functions may not work properly


---
Dennis
 
Posts: 1
Joined: Fri Feb 06, 2015 11:03 am

Return to Fibaro gateways

cron

User Menu

Login